donderdag 4 november 2010
Resistor Board - Part I
Now that my control panel is mostly done, I�ve been trying to figure out the best way to layout the wiring inside to keep it tidy and organized. There are lots of individual circuits, so I decided to use a grid style PC board for the components, such as the bridge rectifiers and all of the resistors.
I realize that I could have probably cut down on the amount of resistors I used, but to keep the wiring as close as possible to my original plan, I opted to keep a resistor for each individual circuit. I�m sure there are a thousand different ways this system could be wired, however this is the one option that I chose. I used my soldering iron to attach the components directly to the board. I will then eventually attach all my wiring to the back of the board to each appropriate component.
Abonneren op:
Reacties posten (Atom)
Geen opmerkingen:
Een reactie posten